FS 8000 DIGITAL INDICATOR
Features :
FEATURES
Control for packer,hopper,checker,limit scale,strain/compression
tester,etc.
Table or panel mounting available .DIN Standard.
Auto span calibration.
Watch-dog function installed for
diagnostic.
Shielded by aluminum case for the immunity against
all forms of radio frequency
interference and the susceptibility.
Wide range of capacity and division can be easily set by keyboard.
Button tare,Digital,Auto tare.
Weight memory back-up for
up to 10years.
Peak-hold and sample-hold function.
High
and low can be set by 2 step control.
AUTO FALL COMPENSATION
RESPONSE SETTING SYSTEM
4 Control relay built-in (HIGH,LOW,FINISH,ZERO/EMPTY)
Weighing operation count can be displayed by function key(COUNT
key).
The external field switch can be directly connected to
5pin terminal located at
the rear panel for the remote control
of some keyboard functions.
(NET/GROSS,PRINT,TARE/HOLD,ZERO)
Can drive up to 8pcs of load cells(350 ¡×Ù ).
Specifications :
SPECIFICATIONS
ANALOG INPUT AND A/D CONVERSION
LOAD CELL EXCITATION
: 10VDC +/- 5% ,320mA
INPUT SENSITIVITY ; 0.2 ¡×Å/D
ZERO ADJUSTMENT RANGE ; -0.4mV~+42.0mV:
COMBINATIONS OF 6BIT
DIP SWITCH
INPUT VOLTAGE : Max.32mV
INPUT IMPEDANCE ;
10m ¡Í¨ª (MIN)
INPUT NOISE : 0.5 ¡×Åp.P or LESS
A/D CONVERTER : TYPE :DUAL SLOPE TYPE
RESOLUTION:1/130,000
COUNTS (17Bit)
CONVERTING SPEED:20TIMES/SEC
NON-LINEARITY
: 0.005% OF FULL SCALE
TEMPERATURE-DRIFT : ZERO +/- 20 PPM/
C
SPAN +/1 20 PPN/ C
OVERLOAD TOLERANCE : +10% OF FULL
CAFACITY
DISPLAY UPDATE RATE : 20 TIMES / SEC
DIGITAL
SECTION
DISPLAY UNIT : 13m/m(1/2 ¡Ì¡Ë),7DIGITS
HIGHLY
BRIGHT FLUORESCENT TUBE
ANNUNCIATORS : STEADY,ZERO,TAPE,
GROSS,AUTO,TXD,HOLD,16ton kg
DECIMAL POINT POSITION : 0, 0.0,
0.00, 0.000
KEYBOARD : TEN KEY,ZERO,TARE,GROSS/NET,
CODE,HOLD,G.T,S.T.AUTO,COUNT
CLR,PRINT,SET/CAL,PART
EXTERNAL INPUT SIGNAL : OPTICAL-ISOLATOR,4INPUT
MIN.DIVISION : x1, x2, x5, x10, x20,x50
MAX.DISPLAY :
1,000,000
REAR PANEL : LOAD CELL INPUT :5PIN CONNECTOR
REMOTE CONTROL : 4 INPUT
RELAY OUTPUT :4 OUT PUT
Model Number :
GENERAL
DATA MEMORY BACK-UP : APPR.10 YEARS
POWER : 100/110/120/220/240VAC
, 10%,50/60Hz
(FACTORY PRESET)
POWER CONSUMPTION ; APPR.
10W
OPERATING CONDITION : TEMPERATURE:-10 C~+40 C (+14 F ~
+104 F)
HUMIDITY :85% Rh Max. (NON-CONDENSING)
NET WEIGHT
: 2.3kg
GROSS WEIGHT ; 3.3 kg
PHYSICAL DIMENSIONS : 192(W)x160(D)x96(H)mm
7.56(W)x6.3(D)x3.78(H) inch
PUSE : 250V/0.3A
Additional Information :
OPTION
OP2:CURRENTLOOP OP5:ANALOG OUT(0~10V)
OP3:BCD DATA OUT
OP6:ANALOG OUT(4~20mA)
OP4:RS-422 OP7:PRINTER I/F
(CENTRONICSPARALLEL
I/F)